I have been a busy bee lately, and I have some cakes to share! The first one is a graduation hat cake, which I made for a lovely young lady who has just completed a degree in Spanish and Maths!
I used a 3D sports ball cake pan to make the actual hat part. And I covered a small square cake board in black sugarpatse for the top of the hat.
I was worried that it might slip off! But I pushed it down quite hard, to make the ball a bit flatter on the top, and then used icing to stick it on and I am glad to report that it did not fall off!
I did make sure I did this at the place the party was being held, I did not dare to travel with it!
There are a few more pictures on my facebook page, so don't forget to check it out: https://www.facebook.com/CustomCakeStudio
Awesome! I have to make a graduation cake also I have never done a 3D cap, thanks for the tip I did not think to use a cake board!!
ReplyDelete